Good Duo R Power Adapter for North America/Canada setup?

Started by PapaBender, 08/31/2018, 04:12 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

PapaBender

I've been using a Sega model 2 as a power supply with the Duo R I recently picked up because it didn't come with one.

Sadly I need this for my Sega setup so I will be looking to replace the power adapter.

Any luck with somewhat "cheaper than the originals" in terms of power supplies? They are not *that* pricey, but if I could save a chunk of cash and have something in spec that doesn't cause any video interference it would be great.

I was looking at this one https://en.retrogamesupply.com/collections/pc-engine/products/power-supply-for-nec-pc-engine-duo-r-duo-rx but noticed it was a switching power supply as per this review below of one they did for the supergrapx

https://www.videogameperfection.com/2018/05/10/supply-supergrafx-review/

Could anyone recommend something that wouldn't introduce any interference? Maybe just get another Sega model 2 adapter? (seems to be 1 V higher)

(also I will being doing the voultar RGB amp soon, sounds like that could be a factor too)

pdiggitydogg

The PWR+ branded adapters on Amazon are supposed to be tested and recommended by retro gaming roundtable. I use one on my DUO (replaced the tip) and haven't had any issues. I'm doing the same for a friend's SCDR² tomorrow.
(They are UL listed)

PapaBender

Thanks - would you have a link handy?

Also did you have to change the tip out? wasn't sure what you had meant.

I'm only running composite out at the moment, but the sega model 2 power seems okay despite being 10V instead of 9V. Not sure what will happen once that Voultar amp goes in though lol.

pdiggitydogg

#3
Im not sure for DUO R, but I have changed the tip for my DUO. You will probably have to look at the polarity and size of the tip when you get it, or review the page for sizing information. If you need to swap tips, I usually go to www.console5.com
https://www.amazon.com/dp/B001BRKFII

edit*
Just checked the tip I cut off against a model 2 genesis and you will need to cut it off -
https://console5.com/store/sega-genesis-2-3-nomad-cdx-power-connector-plug.html

PapaBender

Awesomesauce, thank you sir, will get the ball rolling on that asap :)