PCEngine-FX.com

NEC PC Engine/TurboGrafx-16 Games/Consoles => PCE/TG-16|CD/SGX Discussion => Topic started by: avkooi on 11/01/2006, 06:09 AM

Title: Duo RX drive problems... It keeps spinning and spinning...
Post by: avkooi on 11/01/2006, 06:09 AM
Since a few weeks, I have a very annoying problem with my Duo RX console. Suddenly it stopped loading CD games normally.
When I start the console and press "run" the drive starts spinning very hard, much harder than before. I don't recieve a "load error" or something, it just keeps spinning.

Sometimes after a few minutes the speed goes down to a "normal" level and the game starts eventually. But most of the times it continues with ridiculous fast spinning and nothing happens. Not even a error message.

Is there anybody who has/had the same problem and knows a fix?

BTW: I already tried a new CD lens, but that didn't solve the problem.
Title: Duo RX drive problems... It keeps spinning and spinning...
Post by: rolins on 11/01/2006, 12:05 PM
I got this problem in the past when I was using CDRs with my system. When went back to playing original discs everything was fine again.
Title: Re: Duo RX drive problems... It keeps spinning and spinning...
Post by: CrackTiger on 11/04/2006, 08:55 PM
Quote from: avkooi on 11/01/2006, 06:09 AMSince a few weeks, I have a very annoying problem with my Duo RX console. Suddenly it stopped loading CD games normally.
When I start the console and press "run" the drive starts spinning very hard, much harder than before. I don't recieve a "load error" or something, it just keeps spinning.

Sometimes after a few minutes the speed goes down to a "normal" level and the game starts eventually. But most of the times it continues with ridiculous fast spinning and nothing happens. Not even a error message.

Is there anybody who has/had the same problem and knows a fix?

BTW: I already tried a new CD lens, but that didn't solve the problem.
My Duo RX had a similar problem until I replaced the lens. All I can recommend is checking the lens to make sure it's hooked up properly and none of the wires got tugged out during the original install. I know it was hard for me to remove the original lens without ripping out a couple wires. Of course, I couldn't fully lift up the top shell because of it's other mods...
Title: Re: Duo RX drive problems... It keeps spinning and spinning...
Post by: avkooi on 11/07/2006, 08:28 AM
Thanks for the tips. I already tried a new lens, but the results are the same :-( No game for now... but I will check all the little wires when I return home!