10/31/2023: Localization News - Dead of the Brain 1!

No, NOT a trick, a Halloween treat! Presenting the Dead of the Brain 1 English patch by David Shadoff for the DEAD last official PC Engine CD game published by NEC before exiting the console biz in 1999! I helped edit/betatest and it's also a game I actually finished in 2023, yaaay! Shubibiman also did a French localization. github.com/dshadoff/DeadoftheBrain
twitter.com/NightWolve/PCENews
Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - indianamods

#1
Yep I'm not getting continuity from two pins from under board solder was cold. The one pin thats super short is going to be hard to grab. Is there a Entire HU card slot replacement for these online?
#2
Ill check everything once again. Yes i had a hu card in there same deal white screen, Then if i click off then back on sometimes it goes to yellow.
#3
So i replaced all the caps on the pc engine duo tested and it worked fine, The guy then wanted a region mod where i had to cut the HU card pins and it installed fine until i went to boot it and it goes straight to a white screen.

Later i found i had cut the WRONG pins ](*,)  http://tinypic.com/view.php?pic=apfmu8&s=9

 i then removed the mod and repaired the pins i cut and still have the white screen. So I'm guessing now i have fried a chip?

If it is a chip how would i find out what one? Also where could i order?