12/31/2025: Localization News - Year of the Dragon...Emerald Dragon!
I replaced both motor drivers. I have a spare motor I can try. The motor works fine when I bench tested it. I'm about to give up on this thing but it's becoming a sick obsession that I have to get working or it's going to continue to bother me. I may be in the market for a new one or just the guts that work since the shell I have is in pretty good shape.
 |
Supper the Subtitler struck again! Simply unstoppable, NOTHING can prevent him from TOTAL PCECD localization domination!!!! WHACHA GONNA DO BROTHER?!?! |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Console Repair/Mod Center / Re: Turbo duo won't spin
04/23/2016, 08:32 PM
Put in a new laser still no spinning. The laser does its focus adjust then just says please set disk
#3
Console Repair/Mod Center / Re: Turbo duo won't spin
04/12/2016, 07:14 PM
I have already done a complete recap. I'm now waiting for a second new hop-m3.
#4
Console Repair/Mod Center / Re: Turbo duo won't spin
04/12/2016, 05:46 AM
Everything is clean and rotates freely the laser moves along the rails to the home position as it should.
#5
Console Repair/Mod Center / Re: Turbo duo won't spin
04/11/2016, 06:09 PM
Would the disk still spin if the laser doesn't see anything by turning pots 102 and 104?
#6
Console Repair/Mod Center / Re: Turbo duo won't spin
04/11/2016, 01:55 PM
I got the unit for basically nothing. After opening it up someone had attempted recap but only did a few random caps. After I tore into it a bit I noticed some of the pads were lifted and or missing. So I believe I fixed those that were damaged. I then did a complete recap. And got the unit to power up and play hucards. But no joy on playing CDs. I'm worried that some of the other chips are bad because I tried adjusting the two pots that make the disk spin don't do anything.
#7
Console Repair/Mod Center / Turbo duo won't spin
04/09/2016, 07:17 PM
I recently picked up a turbo duo that was completely dead. Did a complete recap, replaced both 7805, dropped in a new hop-m3, replaced both ba6209a chips. The system now works great for reading cards but the disk will not spin up. The laser moves and does it focus thing but sits for a moment and just says set disk. Tried turning the pots to get the disk spinning but no joy. The motor works. I pulled it and tested it. Any input would be great thanks in advance.
Pages1