Yep I'm not getting continuity from two pins from under board solder was cold. The one pin thats super short is going to be hard to grab. Is there a Entire HU card slot replacement for these online?
 |
The Analogue Turbo Duo clone shipped in time for Christmas 2023. Are you happy with yours ?? Find firmware updates here.  |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Console Repair/Mod Center / Re: Pc Engine Duo White screen Help
12/02/2016, 03:33 AM
Ill check everything once again. Yes i had a hu card in there same deal white screen, Then if i click off then back on sometimes it goes to yellow.
#3
Console Repair/Mod Center / Pc Engine Duo White screen Help
12/01/2016, 10:22 PM
So i replaced all the caps on the pc engine duo tested and it worked fine, The guy then wanted a region mod where i had to cut the HU card pins and it installed fine until i went to boot it and it goes straight to a white screen.
Later i found i had cut the WRONG pins](/forums/Smileys/default/eusa_wall.gif "Brick wall")
http://tinypic.com/view.php?pic=apfmu8&s=9
i then removed the mod and repaired the pins i cut and still have the white screen. So I'm guessing now i have fried a chip?
If it is a chip how would i find out what one? Also where could i order?
Later i found i had cut the WRONG pins
http://tinypic.com/view.php?pic=apfmu8&s=9i then removed the mod and repaired the pins i cut and still have the white screen. So I'm guessing now i have fried a chip?
If it is a chip how would i find out what one? Also where could i order?
Pages1