Console Repair/Mod Center
I have a Duo RX where the controller port is finicky (ie: I need to put a small amount of downward pressure on it for it to work). Does anyone have any experience with this issue and a possible fix? I'm not exactly sure what the problem is, but it might be re-soldering the controller port inside?
So far I have opened up the Duo Rx to take a look at the solder points and I did not see anything strange or loose on the underside of the controller port where the pins and solder is located. Is this something I would able to see with the naked eye?
I was able to jimmy something by putting a little downwards pressure on the port before i closed up the system again and seems to be working fine with the added pressure, but probably not for very long.
So far I have opened up the Duo Rx to take a look at the solder points and I did not see anything strange or loose on the underside of the controller port where the pins and solder is located. Is this something I would able to see with the naked eye?
I was able to jimmy something by putting a little downwards pressure on the port before i closed up the system again and seems to be working fine with the added pressure, but probably not for very long.