10/31/2023: Localization News - Dead of the Brain 1!
Laser seems to be moving back to the center and it will start to spin right at start up but will just stop.
- Welcome to PCEngine-FX.com. Please log in.
 |
No, NOT a trick, a Halloween treat! Presenting the Dead of the Brain 1 English patch by David Shadoff for the DEAD last official PC Engine CD game published by NEC before exiting the console biz in 1999! I helped edit/betatest and it's also a game I actually finished in 2023, yaaay! Shubibiman also did a French localization. |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Console Repair/Mod Center / Re: Turbografx cd Test
07/31/2015, 01:34 AM
At this point im really confused i bought a new laser, even tryed to replace the motor. The gears are spinning fine so im really not sure. The ribbon cables are also put back in right. Will bad capacitors cause it not to spin ? I cant find any faulty caps but i may try to replace them as well if its a possibility.
#3
Console Repair/Mod Center / Re: Turbografx cd Test
07/24/2015, 10:56 PM
Ok ya ive tryed that but it still doesnt spin so thats why i wasnt sure, ive tested the caps and everything on the board looks good and like i said i cleaned and regreased the rail. Is it possible that it wont spin if the laser itself isnt working ? And if so where can i get a replacement if anyone knows ?
#4
Console Repair/Mod Center / Turbografx cd Test
07/24/2015, 10:25 PM
Is there anyway to test out a TG-CD without the system card ? It turns on and cleaned up and reapplyed grease to the rail so its not jammed. I just want to know if i can test it and see if it spins before buying the system card 
. Any help would be great.
. Any help would be great.
#5
Buy/Sell/Trade / Re: Need Turbo express control pcb
07/24/2015, 10:21 PM
I ended up getting it fixed up 
for some reason it took a 2nd time repairing the carbon traces.
for some reason it took a 2nd time repairing the carbon traces.
#6
Buy/Sell/Trade / Need Turbo express control pcb
07/23/2015, 12:16 AM
I recently was given a turbo express and the control pcb is not working if viewed the forms trying to figure out what was wrong because the I and II buttons arnt working and the traces seem fine as does the ribbon cable so at this point im just looking for a replacement control pcb. If anyone has one they can sell or help me out it would be awsome
Pages1