PC-Engine Duo with bad laser motor

[turbokon]

I just finished recapping a pc-engine duo and the disc still doesn't spin.  Tested the motor that moves the laser with AA battery, sure enough it doesn't work.  Anybody happen to have a spare one or know where I can get one?  I had one spare but gave it to someone that need one a while back.

[Bernie]

Took this from one of the guides here.

The motor for the laser (silver cylinder, top of photo 4) is a typical 9V motor that can be found at a hobby store and can be tested for continuity with a 9v battery due to the PCE Duo's 9V voltage. It's hard to get the dang thing back in, de-soldering the wire is the easy part, just watch those gears. The very tiny screws are aluminum, and non-magnetic so make sure you have a steady hand if you have to replace the motor. I've only seen one go bad, ever so I would bet this is not the issue. Make sure to add some extra White Lithium Grease at this point to ensure your gears stay properly lubricated.

https://www.pcengine-fx.com/forums/index.php?topic=8926.0

[NightWolve]

Just to be sure it's completely dead and not the power to it, try a 9V battery or a universal power supply. If it's rated at 9V as that thread suggests, then a 1.5V battery might not do anything.

[turbokon]

It's 9v rated meaning max operating voltage the motor can handle.  It shouldn't take much voltage to turn but yeah I can test it some more.

[Keith Courage]

I've actually used the same motor that goes in a standard TG16 drive as a replacement. Mounts slightly different but works just fine. Holes line up no problem. http://www.ebay.com/itm/5pcs-Wholesale-FF-050-Motor-3-12V-DC-RC-Car-Model-DIY-Shaver-Toothbrush-Motor-/231157654784?pt=LH_DefaultDomain_0&hash=item35d211e500

And yes I have been starting to come across a lot of DUOs with bad lens motors lately.

[NightWolve]

Confirmed Shawn, it's totally dead ?

[turbokon]

Yep, it's dead. 

In the mean time, I pulled the motor from another duo I've have yet to refurb. 

Will be looking for another motor. 

[thesteve]

Any motor that has matching screw holes will work (6-20 volt motors)