TG16 RGB mod, blurry color bleeding

[LaC]

I recently RGB modded my TG16.
I used the RGB amp here -> http://www.gamesx.com/grafx/pce_rgb.jpg


I tried to hook it up to my Sony PVM 2950Q with the amped pure sync as in the diagram.  However, it would not sync properly.  So I switched the sync part of the amp to just use an lm1881n instead and fed it composite and extracted the sync from that. That gave me a fairly nice synced image.
However, there is one annoying problem, there is color bleeding like seen below.
Anyone know what would cause this?

[CGQuarterly]

PVMs can use composite video as sync.  Try taking the LM1881 out of the equation and see what happens.  Also, that picture looks like the image is too bright.

[Duo_R]

what jibba said or perhaps this is a grounding issue?

[LaC]

The PVM-2950Q doesn't accept composite as sync.  I always have my consoles output raw sync.   When I try the tg16 with composite as sync I just get a black screen.
I do have a PVM-2030, which likes composite as sync. I'll have to give that a try to see if I get the same problems.
The brightness of the screenshot is just the exposure settings on the camera.

[LaC]

The PVM-2950Q doesn't accept composite as sync.  I always have my consoles output raw sync.   When I try the tg16 with composite as sync I just get a black screen.
I do have a PVM-2030, which likes composite as sync. I'll have to give that a try to see if I get the same problems.
The brightness of the screenshot is just the exposure settings on the camera.

Yeah, tried my PVM-2030. I don't get any problems there both with regular composite as sync and the output from the lm1881n.