Good spot to mount Obey chip on Turbografx 16

[Shear_xear]

Hi everyone!  I was installing my Obey chip in my Turbografx 16 and mounted it on the plastic shield over the Hu Card slot.  When I went to put the shell back on I found it was not going to work as the wires were keeping the shell from "locking" into the motherboard.  Where is a good place to put the chip that won't damage the motherboard?  Thanks!  Mike

[turbokon]

Which version obey chip are you using?

[thesteve]

there are 2 punch outs on that board, i punch the one by the slot and set the board there

[Shear_xear]

Awesome!  I thought those looked like they were unused areas, but punch out?  Thanks so much!! Mike