Which screwdriver opens the FX?

[MissaFX]

Anyone know which driver I need to order to open this baby up?

[Duo_R]

Missa, based on our conversation on the chat it sounds like it is the same as the Duo-R bit (star with middle pin). U can either use a small jewelers flathead (it will catch) or buy the bit at local hardware store. It is a security bit.

[Arkhan Asylum]

HAMMER!

[nat]

Yeah, same security Torx as the Duo-Rs. Security T-10 I think. Maybe T-15.

[MissaFX]

I ended up doing the getto method and used a small standard screwdriver and was just super careful.

It's so silly they use this type of screw on the bottom of the case when the screws securing it in the back are phillips like every screw inside it.

[Duo_R]

Missa I am going to take my to the hardware store and replace with standard screws with the same threading...

[MissaFX]

Missa I am going to take my to the hardware store and replace with standard screws with the same threading...

Tell me what exact screw works so I can buy a box of them.

[Duo_R]

well no I am not going to replace the screws, I found the bit at a hardware store:

The bit u need is T10 "Security Tee Star." Works like a charm. Missa if u can't find let me know and I can pick one up for you.

[nat]

The bit u need is T10 "Security Tee Star." Works like a charm.

Didn't I just say that a few messages back? 

[Duo_R]

Yup - just clarified on T-10 VS T-15.....

LOL

Yeah, same security Torx as the Duo-Rs. Security T-10 I think. Maybe T-15.

[blueraven]

The bit u need is T10 "Security Tee Star." Works like a charm.

Didn't I just say that a few messages back? 

Yes.