Turbo CD clip Fail.

[DeshDildo]

Well, I acquired another broken TGCD drive with dock from a friend.  The middle gear was questionable but worked.  I recapped the drive and ended up having a bad laser as well.  I installed a new laser I had received from Keith Courage awhile back.  I dialed in the pots and played the crap out of it.  After sitting for about a week I went to test it again and found the drive wouldn't work.  Took it apart and found the middle gear was the culprit but it would work again if I bumped it free.  I decided to replace the gear being very careful not to lose the holding clip.  While re-installing the clip with the new gear in place I dropped it into the assembly somewhere.  The bitch is I've torn the thing completely apart and cannot find the clip anywhere and I've spent the last 2 hours or so trying to find it. 

I am mucho pissed at myself right now.  So, how screwed am I?  Am I going to be forced to start buying up cheap CD mechanisms to find a suitable replacement or does somebody know of a source for one?

[Keith Courage]

Talk to choijimmy. https://www.pcengine-fx.com/forums/index.php?topic=20766.0

[DeshDildo]

Talk to choijimmy. https://www.pcengine-fx.com/forums/index.php?topic=20766.0

Thank you for the link sir!

[pas7680]

replacements are impossible to find as no one else seems to have ever used such a small retaining clip, however what i use is a c-ring - i think that's what they're called and they can be found in sizes below 2mm id. They're still a little big but careful squeezing with pliers you can close the gap down to around the 1.5mm required.

[thesteve]

I make a clip from a cap lead

Sent from my VS920 4G using Tapatalk